Minute Man (oz1831)

About this Plan

The Minute Man. Free flight rubber model. Popular Science June 1941.

Quote: "THIS little plane, capable of flights of over 2,000 feet can be built and launched in less time than is usually required to construct the fuselage of more complicated models. Its sturdy, simple design is an instructive example of what can be done with lightweight and quarter-grained ('C' cut) balsa sheets (see PSM, Dec. '40, p.198).

In selecting the balsa, see that it is light and shows the speckled sur-face which identifies C grain. Cut the fuselage and wing parts cleanly with a sharp blade to produce smooth edges. The dimensions of the fuselage cross braces should be taken from the numbered scale which appears in the drawings. Notice, in the detail of the nose, bow the eight braces are offset for maximum strength. Spread cement carefully along the full length of the edges when assembling the fuselage. The top and bottom sheets are trimmed flush with the sides after the cement has hardened.

The wing camber is obtained by moistening the under surface with water, and allowing the single end rib to extend the camber along each wing. The sheet may at first tend to curve upward, but will assume the proper downward curve as it dries. When it is quite dry, apply broad streaks of cement to the underside, as shown in the drawings. These are important.

Cut the propeller blank from a straight-grained block of balsa, 7/8 by 1-1/8 by 8 inches. Because no model plane is better than its propeller, the builder is urged to read the instructions given in the article following this one.

The freewheeling device shown in the plans operates in this way: The long hook is so fastened to the propeller that it normally springs out of contact with the triangular hook on the motor shaft. After the rubber is wound, the hooks are engaged by hand. When the motor has been exhausted in flight, the propeller overruns the shaft, and the long hook springs free, permitting the propeller to turn upon the shaft.

It is important that there be no friction between propeller and shaft once the hooks are disengaged. A drag at this point may cause the propeller to act as a rudder during the glide, spoiling the model's performance. In the case of a small ship such as this, a dragging propeller may even cause it to spin down in a spiral dive when the rubber is exhausted.

The motor consists of six strands of 1/8 flat rubber. Form it by winding the rubber over two nails placed 15 in apart. Wet the ends, and tie with several knots. Lubricate the motor with glycerin before pulling it through the fuselage.

The nose block is made of two parts cemented together, its upper face being grooved for the rubber band which holds it to the fuselage. An eyelet is used for the shaft bearing. The fuselage shape shown will give the nose block an offset or down thrust of 1/16 in. After test flights have been made, or when the motor to be wound up for maximum duration (700 turns), the nose block should be given about 1/16 in right thrust. Only experiment will determine exactly the correct amount.

Before flying it under power, test the model's glide. Move the wing back if the ship stalls, or forward if it tends to dive. The rudder may be warped if a circular flight is desired. After a smooth, flat glide is obtained, make a test flight with the motor partly wound, and correct the wing setting if necessary. Once the adjustments have been made, the ship should readily make flights of more than a minute's duration in calm air."

Supplementary file notes

Planfile includes article.

Corrections?

Did we get something wrong with these details about this plan (especially the datafile)? That happens sometimes. You can help us fix it.
Add a correction