Flip (oz16682)

About this Plan

Flip. Radio control sport model. Canard pusher layout. For electric power with Speed 600 motor.

Quote (google-translated): "FLIP Assembly Instructions.

Dear Customer, You have chosen an exceptional model and will certainly enjoy it immensely. Its flight performance and handling characteristics are excellent. It is easy to fly and therefore well-suited even for inexperienced pilots. If you already have sufficient flying experience, you can perform breathtaking aerobatics with this model, including the most exhilarating maneuvers. The model is designed for electric propulsion but can also be equipped with internal combustion engines up to a maximum of 3.5 cc.

Before you begin assembly, please check the kit for completeness. Read the assembly instructions completely before proceeding step-by-step with the construction of the towing model.

Scope of Delivery:

1 set of main wing panels, 1 canard wing, 2 winglets, 1 package of small panels, 1 package of strips, 1 bag of wooden parts, 1 bag of small parts, 1 fiberglass canopy, building plan, assembly and test flight instructions

The parts are largely pre-machined and precisely fitted. The wings are supplied with a slight washout. This is not warping. Bowden cable tubes and a tube for the receiver antenna are already installed.

Package Contents: Fake boards: 2 side panels, 1 base, 1 balsa sheet for canopy.
Package of strips: 6 balsa strips 5 x 10 mm, 2 triangular strips 10 x 10 mm, 2 balsa final pieces.
Bag of wooden parts: Various pieces of wood and strip sections
Bag of small parts: 1 clevis, 4 clamping heads, 2 control horns with fixing screws, fiberglass mat 79 g/m², gas mat 40 g/m², 1 plastic screw M4, 5 threaded inserts M4, 4 T-nuts M4, elevator linkage, 1 screw base with mounting hardware, 1 ABS die-cast part

SW-Modellbau GmbH, P.O. Box 6, 8912 Kaufering

Model Assembly: When assembling the model, please follow the instructions precisely. Before each step, prepare the necessary parts.

3.1 - Hull

(1) According to the plan, mark the positions of the frames on the side panels. Ensure that the markings are made on the inside. (Parts R1, R5, R6).

(2) Cut the longitudinal stringers and triangular strips to length according to the plan and glue them to the inside of the side panels. Secure with pins until the glue has hardened. (Parts R1, R8, R9)

(3) Cut the reinforcements for the engine compartment, fit them into the side panels, and glue them in place. (Parts R1, R10)

(4) Mount the screw bases onto the main bulkhead. (Parts R6a, R6b)

(5) Glue the nose block to the end panel. (Parts R3, R4)

(7) Remove the side panels from the roughing board and lightly sand them.

(8) To ensure the fuselage can be glued together at right angles, a center line must be drawn on the building board.

(9) When gluing the nose block and all bulkheads together, ensure their centers align with the center line on the building board. (Parts R5, R6)..."

Direct submission to Outerzone.

Quote: "hi Mary hi Steve, have a plan for you also with building instruction in german.
Regs
Doro"

Corrections?

Did we get something wrong with these details about this plan (especially the datafile)? That happens sometimes. You can help us fix it.
Add a correction