All In One Field Box (oz15419)

About this Plan

All In One Field Box.

Quote: "Hi, Attached the plans and article of the RCM all in one field box. I got them from hip pocket aeronautics. Also attached my CAD file of a modified version including all the cuts for laser cutting and a photo [main pic]. In the DXF you will find a text with an overview and comments. Best regards,"

Direct submission to Outerzone.

Quote: "All In One Field, by Robert Lansdale, Jr. How often have you arrived at the local flying site, minus fuel, starter or even the fuselage of your R/C model? Borrowing a missing item may be all right now and then, but it is far better to prep in an orderly fashion and arrive ready for action.

This field box will go a long way in getting your act together. It has room for everything but the kitchen sink, so there's no excuse for acting the part of the absent-minded professor! Incorporating an aircraft cradle, easy access starter and handy tool shelf, this field box can do wonders for your ego (an important part of getting the day's flying off to a good start). This field box fits in most any car trunk and the all-up weight is about 30 pounds. Best of all, the cost is a mere $8.00 orless (far less if your workshop contains some of the required material).

Depending on the particular type of models you fly, feel free to modify it to suit your personal taste, but be sure to use materials of equivalent strength if you do substitute. Do not change the location of the fuel or battery they are in the center to keep the balance right. Any old broom handle can be used, but if it has a weathered finish, give it the old sandpaper/elbow grease treatment to avoid the possibility of splinters in your hand later on.

Note on the full size plan that small sketches (A and B; also drawer assembly detail) clarify the construction sequence. If you so choose, you can cut parts slightly oversize and sand to finished size with a belt-type sander (or file and sanding block). It is best, however, to cut the parts accurately - less time wasted. And you'll be a better model-builder in establishing good construction techniques.

First cut out the bottom (Part 1) to size of 1/2 in plywood. Then jig-saw the ends (2A and 2B) to shape. Take a glance at sketch A now - the main compartment dividers (3A and 3B), plus the small Part 30 and the front and back panels (4A and 4B) should all be cut out before initiating any assembly work. Now, glue the ends to the bottom, using 5/8 or 3/4 in brads or finishing nails for extra strength. Carefully measure and mark the position (on Part 1, the bottom) of Parts 3A and 3B. Glue both in place. Take the time to see that all parts that have been assembled at this stage have all their edges flush, front and back. If not, sand any projecting sections until true, so that the front and back panels fit accurately..."

Supplementary file notes

Article.

CAD file

This plan is available for download in CAD format.

Corrections?

Did we get something wrong with these details about this plan (especially the datafile)? That happens sometimes. You can help us fix it.
Add a correction