Stunt P-51 Mustang (oz15152)

About this Plan

Stunt P-51 Mustang. Control line stunt model.

Direct submission to Outerzone.

Quote (google translated): "The P-51 Mustang is the product of the experiences of a staff made up of the best aerobatic model designers. It is a semi-scale reproduction of the very famous American fighter and in designing it we followed the lines of the real plane as faithfully as possible without neglecting the exact rules of a perfect aerobatic.

Start building your P-51 Mustang from the wing; glue the wing drawing to the section. A-A and place it on a surface. Join and glue the leading edge (13) with no. 9 and the trailing edge (15) with no. 12. Now place the 6x6 balsa spars (14) on the drawing and insert all the ribs, checking the exact position on the drawing (the ribs have protrusions at the bottom for exact alignment.

Now fit the leading edge and exit, align everything perfectly and finally insert the upper spars (14). Join the lower spars with No. 11 and the upper ones with No. 10 in the center by gluing. Now glue all the joints.

When the glue is perfectly dried, detach the wing from the surface, glue the details n. 5-6-7-8- in position, then prepare the square n. 19 with the appropriate tie rods and fix it with the appropriate screw to the No. 11. Glue the supports of the carriage No. 20 into position, checking all the details of the drawing, then proceed to covering the central part of the wing with balsa board.

Sand everything carefully and after gluing onto the half-wing external 15 grams of lead (P) proceed to cover it with paper. Glue the covering then moisten it with water and once dry, apply two coats of diluted glue.

Sand and profile the flaps n. 16-17, fix the sheets together with the appropriate bracket, checking the design, then proceed to hinging the wing using the appropriate hinges no. 18. At the same time you will also have built the horizontal tail plane using the same system as the wing. Now begin construction of the fuselage. Strongly glued to the sides n. 36 reinforcements n. 37 and the engine support rails. Insert the tank and glue the frames no. 22-23..."

Supplementary file notes

Instructions.
Parts.

Corrections?

Did we get something wrong with these details about this plan (especially the datafile)? That happens sometimes. You can help us fix it.
Add a correction